Job log for joiners
Behind kitchen units and fitted wardrobes sit the wall fixings, the cut-outs for water and power, and the levelling. Photograph them during fitting and record the client’s decisions (finish, edging, handles) in writing, and you can point to both if there is a dispute later.
The kitchen is in, but six months later a wall unit sags, or the client says they ordered a different finish. The question is then what it was fixed with and where, and what was approved — and the answer is in an old chat, or nowhere.
In JobOptim the survey, the client’s decisions and the fitting steps go on the job with photos and a timestamp. Client requests and change orders are their own entries, the client follows on the progress page, and at handover a PDF report is built.
What to photograph
A suggestion, not a rule: these are the steps that end up hidden later.
Panel cutting optimizer on CutOptim →How it works
- 01
Record it on site
A photo and a short entry from your phone; you can dictate it too.
- 02
The client follows
On a link or by QR code, without an account.
- 03
Hand it over
A PDF report is built from the entries you select.
What it does not do
- It does not replace an official construction log where the law requires one.
- It does not calculate material quantities – that is what the CutOptim calculators are for.
Frequently asked questions
How do I record that the client approved the finish?
As a client request or work-done entry with a photo of the sample; mark it client-visible and they see it on the progress page too.
Does JobOptim calculate panel cutting?
No: the cutting plan comes from the CutOptim panel cutting optimizer.